Striker Replacement; Door Trim Panel Replacement; Bumper Wedge Replacement - GMC G Service Manual

10A1-74 DOORS
This measurement should be taken on each door
individually from the side of the door. The door should
be in its normal closed position. (The outer rear door
panel is 15.25 mm ± 0.5 mm (0.60-inch ± 0.02-inch)
away from the rear platform panel when normally
closed.)
3. The rear door outer panel to the body side outer panel
gap to 4 mm ± 0.5 mm (0.16-inch ± 0.02-inch).
4. The door to door clearance between the left and right
outer door panels should be 6 mm ± 0.5 mm (0.25-
inch ± 0.02-inch).

STRIKER REPLACEMENT

M Remove or Disconnect (Figure 110)
1. Striker to door frame bolts (486).
2. Striker from the door frame.
3. Spacer (if equipped).
M Install or Connect (Figure 110)
1. Spacer (as required).
2. Striker to the door frame.
3. Striker to door frame bolts (486).
Adjust (Figure 111 )
• The striker to door latch clearance so that there are
4.4 mm (0.172-inch) between the striker and the door
latch when the door is in the secondary latched posi­
tion. (The door is latched but not fully closed.) An
11/64-inch diameter drill bit may be used to gage this
clearance.
Figure 110 — Striker Components
487
486. Bolt
487. Striker
488. Spacer
A. 4.4 mm
(0.172
486
Figure 111 — Striker Components
DOOR TRIM PANEL
REPLACEMENT
B
Remove or Disconnect (Figure 112)
1. Door trim panel to door screws (489).
2. Door trim panel from the vehicle.
B
• Slide the panel out of the retainers.
Install or Connect (Figure 112)
1J Door trim panel to the vehicle.
• Slide the panel into the retainers.
2' Door trim panel to door screws (489).
B

BUMPER WEDGE REPLACEMENT

Remove or Disconnect (Figure 113)
11 Bumper to upper door frame screws (495).
2. Bumper and spacer.
|++| Install or Connect (Figure 113)
1. Spacer (as required).
2. Bumper.
3. Bumper to upper door frame screws (495).
Adjust
The bumper to door clearance so that there is 1 mm
(0.04-inch) between the bumper and the door when
the door is in the secondary position. (The door is
latched but not fully closed.)
F-00552