Right Door Weatherstrip Replacement; Power Door Lock Motor Replacement - GMC G Service Manual

RIGHT DOOR WEATHERSTRIP
REPLACEMENT
H Remove or Disconnect (Figure 123)
1. Weatherstrip from the door using 3M Release Agent
(or equivalent).
2. Plastic nails from the door frame.
538. Weatherstrip
539. Plastic Nail
Figure 123 — Right Door Weatherstrip
M Clean
• The door and weatherstrip of all the old cement.
H Install or Connect (Figure 123)
1. New weatherstrip to the door using 3M Weatherstrip
Adhesive (or equivalent).
• Push the plastic nails into the door frame.
POWER DOOR LOCK MOTOR
B
Remove or Disconnect (Figure 124)
1. Battery ground cable.
2. Door trim panel. Refer to "Door Trim
Replacement."
3. Electrical connector from the motor.
4. Door to motor screws (540).
5. Motor from the lock rod.
• Slide the rubber mount at the top of the motor
off of the door lock rod.
B
6. Motor from the door.
Install or Connect (Figure 124)
1. Motor into the door.
2. Motor to the lock rod.
• Slide the rubber mount at the top of the motor
onto the door lock rod.
3. Door to motor screws (540).
4. Electrical connector to the motor.
5. Door trim panel. Refer to "Door Trim
F-00564
Replacement."
6. Battery ground cable.
DOORS 10A1-81
REPLACEMENT
Panel
Panel