Intermediate Rear Door Upper Latch Replacement; Intermediate Rear Door Control Assembly Replacement - GMC G Service Manual

K H Install or Connect (Figure 84)
1. Lower latch with the rod to the door.
2. Lower latch to door screws (349).
3. Lower latch to control assembly rod into the control
assembly.
• Pivot the clip onto the rod.
4. Door trim panel. Refer to "Door Trim Panel
Replacement."
347. Lower Latch Rod
348. Lower Latch
349. Bolt
e J c o =i
4 ^ 3 4 9 - ^ 1 1
Figure 84 — Intermediate Rear Door Lower Latch
INTERMEDIATE REAR DOOR
UPPER LATCH REPLACEMENT
M Remove or Disconnect (Figure 85)
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
2. Upper latch to control assembly rod from the control
assembly.
• Using a flat bladed screwdriver, push on the top
of the clip where it is connected to the rod. Pivot
the clip away from the rod.
3. Upper latch to door bolts (350).
4. Upper latch with the rod from the door.
M Install or Connect (Figure 85)
1. Upper latch with the rod to the door.
2. Upper latch to door bolts (350).
3. Upper latch to control assembly rod into the control
assembly.
• Pivot the clip onto the rod.
4. Door trim panel. Refer to "Door Trim Panel
Replacement."
-------- 3 4 7
gBp---------3 4 8
F-00513
INTERMEDIATE REAR DOOR
CONTROL ASSEMBLY
REPLACEMENT
h 4 | Remove or Disconnect (Figure 86)
1. Door trim panel. Refer to "Door Trim Panel
Replacement."
Upper and lower door latch rods from the control
2.
assembly.
• Using a flat bladed screwdriver, push on the top
of the clip where it is connected to the rod. Pivot
the clip away from the rod.
Electric door actuator (if equipped).
3.
4. Lock knob (356).
Rear door inside handle screw
5.
(365).
6. Rear door lock rod clip at the door panel.
• Pivot the clip away from the rod.
Door to control assembly bolts
7.
8. Control assembly with lock rod through the access
hole.
E Install or Connect (Figure 86)
1. Control assembly with lock rod through the access
hole.
2. Door to control assembly bolts
Rear door lock rod clip at the door panel.
3.
• Pivot the clip onto the rod.
Rear door inside handle
4.
Lock knob
5. (356).
6. Electric door actuator (if equipped).
Upper and lower door latch rods to the control
7.
assembly.
• Pivot the clip onto the rod.
8. Door trim panel. Refer to "Door Trim Panel
Replacement."
DOORS 10A1-57
and handle
(364)
(363).
(363).
and screw
(365) (364).