Connecting The Ip Multiline Terminal To The Network And Pc - NEC UNIVERGE SV8100 System Hardware Manual

Issue 5.0
4.3
5 - 26

Connecting the IP Multiline Terminal to the Network and PC

These instructions for connecting an IP Multiline Terminal to the Network and
PC apply to DT700 Multiline Terminals. Refer to
Connector Locations.
1. Connect the LAN Network
connector.
2. The IP terminal has a switching HUB to connect a PC to the LAN
Network. Connect the 10 Base-T/100 Base-TX straight cable used for
this connection to the PC(x) connector and to the PC.
Refer to Figure 5-21 Typical Network IP Connection on page
LAN (=) PC(x)
Connections
Figure 5-20 IP Terminal Connector Locations
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
Figure 5-20 IP Terminal
10Base-T/100Base-TX
UNIVERGE SV8100
cable to the LAN (=)
5-27.