NEC UNIVERGE SV8100 System Hardware Manual page 316

Issue 5.0
5 - 58
3.
4.
5.
6.
Figure 5-64 Ribbon Cable Connector
7.
8.
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
Remove the screw (refer to
Side Panel from Multiline Terminal on page
Carefully, return the multiline terminal to the buttons
side up position.
Remove the soft keys and line key kit from the
telephone.
Gently lift the small black bar to open the ribbon
cable connector.
Plug ribbon cable on back of 8LKI (LD)-L UNIT into
connector (metal side down) until pressure is felt.
Press down on the black bar to lock the cable into
place (refer to Figure 5-65 Ribbon Cable Installed
on page 5-59).
UNIVERGE SV8100
Figure 5-63 Remove
5-57).
Lift
Here