Stand Mounting The 9.5" Chassis - NEC UNIVERGE SV8100 System Hardware Manual

Issue 5.0
2.6
3 - 36
11. Using the key-holes as a guide, slide the assembled unit over
the screws previously installed in the wall (refer to
Install Screws (Option 2) on page
12. Connect grounding wire to chassis. Refer to
9.5" Chassis on page 3-54
the system.
13. Refer to
continue installation of the chassis or, Chapter 6 paragraph
Installing an Extension or Trunk Blade on page 4-4
installation of blades.

Stand Mounting the 9.5" Chassis

The 9.5" chassis can be stand mounted using the brackets supplied. The
following section describes this procedure.
1. Lay the two bracket halves on a flat surface.
Figure 3-40 Position the 9.5" Stand Mount Brackets
2. Using the slots on the sides of the 9.5" chassis as guides, insert the
stand mount brackets into the chassis (refer to
Stand Mount Bracket
Mount Bracket on page
for complete details on grounding
2.8 Installing the 9.5" Chassis on page 3-54
and Figure 3-42 Attach Remaining 9.5" Stand
3-37).
UNIVERGE SV8100
Figure 3-34
3-31).
2.8 Installing the
to
for
Figure 3-41 Attach 9.5"
Installing the SV8100 Chassis
2.2