NEC UNIVERGE SV8100 System Hardware Manual page 390

Issue 5.0
6 - 36
4. Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5. Lay the tilt leg and the leg support flat to expose ADA-L UNIT
compartment.
6. Carefully pry loose the knockout covering the bottom option
interface (refer to
Knockout).
Knockout
Figure 6-25 Bottom Option Interface Knockout
7. Using the exposed Bottom Option Interface as a guide, install
the ADA-L UNIT in the bottom of the DTL/ITL multiline terminal.
Push down until left and right tabs are seated (Refer to
6-26 Install ADA-L
Tab
Bottom Option
Interface
8. Return tilt leg to original position.
9. Reconnect all cables previously disconnected.
Figure 6-25 Bottom Option Interface
UNIT).
Figure 6-26 Install ADA-L UNIT
Installing SV8100 Optional Equipment
UNIVERGE SV8100
Bottom Option
Interface
Figure
Tab