NEC UNIVERGE SV8100 System Hardware Manual page 252

Issue 5.0
4 - 104
MDI/MDI-X Auto Crossover
Tag VLAN Based on IEEE802.1Q
Port-Base VLAN
Port Mirroring
PPPoE Client
Multi-Protocol Bridge
RIP/RIPV2/OSPFv2/BGP4
Policy Routing
DHCP
NAT/NAPT
SIP-NAT
IPnP NAT Traversal
DNS Proxy
NTP/SNTP
QoS (PQ, CBQ, LLQ, Shaping)
VPN (IPSec/IKE)
AAA (Login)
Firewall (Static/Dynamic Filter)
SNMPv1
Syslog
TFTP Client
Backpressure/Flow Control Feature
Auto MAC Address Learning/Migrating/Aging
Learn Maximum 8k MAC Addresses
Store and Forward Switching Method
Maximum 100m Transmission Distance by CAT-5 Cable
2 Status LEDs
The VoIPDB, which is required for IP telephones to communicate
with non-VoIP UNIVERGE SV8100 telephones, and place or receive
outside calls, must be connected to either an external switching hub
or to the Router blade.
The blade plugs into a universal slot and does not consume any
ports. Each blade provides eight RJ-45 port connectors. These are
used to connect to LAN terminals. Depending on the type of LAN
UNIVERGE SV8100
Installing the SV8100 Blades