Network Loss - 3xLogic VX-2A-B-IWD User Manual

NETWORK LOSS

Steps:
1). Opening the Setup Tab>Event Configuration drop-down menu and clicking the Network Loss
link will open the Network Loss settings page.
Figure 7-32: Setup Tab – Event Configuration Menu – Network Loss Settings
2). From the Network Loss settings page, a user may configure the following network signal loss
settings:
Stream Setting Description
Check Ethernet
Enable the camera to check for Ethernet (physical) connectivity.
Connectivity
Check Ping
Enable the camera to check for network connectivity, via network ping.
Response
Interval Configure the time interval in between checks/pings.
Enter the address of the device you would like the camera to ping. When this
Host Address device cannot be reached/ a ping response is not received, the camera will fall
into a network loss state.
3). Click Apply to save changes to network loss settings.
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
VIGIL Software v8.8 User Manual | VISIX V-Series All-in-One Cameras
73