White Balance Settings; Image Signal Processing Settings; Video Stabilization Settings - 3xLogic VX-2A-B-IWD User Manual

WHITE BALANCE SETTINGS

Steps:
1). Under the White Balance section, a user may choose the cameras White Balance Mode
setting from the drop-down. Red and Blue color temperature settings can also be adjusted
using the slider bars.
Figure 7-17: Setup Tab – Video Menu – Camera Settings – White Balance Settings

IMAGE SIGNAL PROCESSING SETTINGS

Steps:
1). Under the Image Signal Processing section, a user may configure the cameras 2D DNR (2
Dimension Dynamic Noise Reduction) setting. Increasing this setting can reduce noise
surrounding moving objects within the field-of-vision. Adversely, this can increase blurring and
smudging around static objects.
2). If the camera is heated, Defog mode can also be enabled in this section. After enabling defog,
the Defog Level can be selected in the drop-down menu.
Figure 7-18: Setup Tab – Video Menu – Camera Settings – Image Signal Processing Settings
3). The default setting is 3.

VIDEO STABILIZATION SETTINGS

Steps:
1). Under the Video Stabilization Settings section, a user may enable Video Stabilization for any
of the camera's stream profiles (First/Main, Second/Sub, and Snapshot). Check-off the box
adjacent to each stream you wish to apply Video Stabilization too. The Border Fill-In setting
can be chosen from the drop-down menu.
NOTE:
Video stabilization settings may be automatically disabled depending on the presence of other camera
settings. Conflicting settings will be listed (orange text, below).
Figure 7-19: Setup Tab – Video Menu – Camera Settings – Video Stabilization Settings
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
VIGIL Software v8.8 User Manual | VISIX V-Series All-in-One Cameras
61