Vigil Vcm - Adding A V-Series All-In-One Camera - 3xLogic VX-2A-B-IWD User Manual

VIGIL VCM - ADDING A V-SERIES ALL-IN-ONE CAMERA

Steps:
1). To add a VISIX All-in-One Camera to VCM for central management and health-monitoring
purposes, launch a VCM Client.
2). Log into a VCM Server.
3). Click the Health Monitor button.
4). Select (left-click) a Server Group from the Server Groups sidebar to. The All-in-One camera
will be added to this group.
5). Click the Add Server button (only available after selecting an applicable Server Group). This
will launch the Add/Edit Server form. VISIX All-in-One devices are considered edge recording
devices, and thus are recognized as their own Server within the VIGIL suite, including VCM.
6). Check off VIGIL Camera. This will indicate to VCM that the device you are adding is a VISIX all-
in-One camera.
7). Check-off Use VIGIL Connect. Alternatively, if you wish to use traditional network connection
criteria, leave Use VIGIL Connect disabled and enter in IP/DNS Name and Port info (if using
standard network connection values, also ignore step 8 of these instructions) for the device.
8). Enter the VIGIL Connect alias of the All-in-One camera in the Serial No./Alias field.
9). After entering an alias, click Test VIGIL Connect to ensure successful communication with the
VIGIL Connect system.
10). Fill in all remaining required fields and click OK to add the camera to your list of centrally
managed VIGIL Servers/VISIX All-in-One cameras.
If you experience issues connecting to the All-in-One camera in VCM, confirm the alias that has been
entered is correct. If all settings appear to be correct, contact 3xLOGIC for further instruction or
reference Tech Tip 140028 VIGIL Connect Troubleshoot Guide
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
VIGIL Software v8.8 User Manual | VISIX V-Series All-in-One Cameras
Figure 4-25: Adding an All-in-One Camera to VCM
for troubleshooting tips.
33