Table of Contents
Advertisement
Configuring Recording Schedule for setting the recording schedule.
CONFIGURING VIDEO TAMPERING ALARM
Purpose:
The user can configure the camera to trigger an alarm when the lens is covered / obscured and also configure
certain alarm response actions when tampering is detected.
Steps:
1. Enter the Video Tampering settings interface: Configuration > Event > Basic Event > Video
Tampering
2. Check Enable checkbox to enable the tampering detection.
3. Click
configuration is identical to configuring the arming schedule for motion detection. Refer to Section
5.2.1 Configuring Motion Detection.
4. Click
Center, Send Email and Trigger Alarm output are selectable. Refer to Section 5.2.1 Configuring
Motion Detection for more information on configuring linkage methods.
5. Click
CONFIGURING VIDEO LOSS
Steps:
1. Enter the Video Loss settings interface: Configuration > Event > Basic Event > Video Loss
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
VISIX S-Series Network Camera | USER MANUAL v6.0
Tampering Alarm
Figure 5-15
tab to enter the arming schedule settings interface. The arming schedule
tab to select the linkage method taken for tampering. Notify Surveillance
to save the settings.
40
Hide quick links:
Advertisement
Table of Contents
