3xLogic VX-2A-B-IWD User Manual page 22

The tripwire will now tally separate counts for both configured directions. To display counts for each
direction on-screen, a VCA counter must be configured. To configure a counter for use with your
counting line/tripwire:
7). Right-click within the viewing area and select Counter>Add Counter
8). Place the counter overlay in the desired position.
9). Assign a Name and Color (In Counter and green used in the above example, respectively).
10). Configure the counter's Increment rule
i. Check off Inc 0.
ii. Set the Inc 0 value to the desired trip wire/counting line. In the above example, Inc 0 is set
to increment whenever Counting Wire 1 – In is triggered.
11). Repeat Steps 7-12 to create a separate counter for Counting Wire 1 – Out
12). Click Apply to save the new counter settings.
The tripwire should now count both directions and display counts via the configured counters. For
instructions on previewing your analytics overlay, see
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
VIGIL Software v8.8 User Manual | VISIX V-Series All-in-One Cameras
Figure 4-10: Configuring a VCA Counter
Previewing Analytics Overlay.
22