Event Configuration Menu; Event Rules - 3xLogic VX-2A-B-IWD User Manual

2). Select the BNC output mode. Choose between NTSC (60Hz) or PAL (50Hz, auto color
correction). The optimal setting is dependent on the monitor receiving the video output from
the camera.

7.3 Event Configuration Menu

EVENT RULES

Steps:
1). Opening the Setup Tab>Event Configuration drop-down menu and clicking the Event Rules
link will open the Event Rules settings page.
Figure 7-26: Setup Tab – Event Configuration – Event Rules Settings
2). From the Event Rules settings page, a user may enable and subsequently Add a new event
rule. A user may also Copy, Modify or Delete and existing event rule.
3). To enable, check-off the Enable Event Rules box.
4). Select a rule from the list to display its Event Source and Event Action specifications under the
Information section.
By default, VISIX V-Series All-in-One Camera's will have events enabled and with a single motion record
rule configured, designed to trigger footage recording when motion is detected. This allows for
recording directly out-of-the-box with no user interaction required.
5). To copy or delete an existing rule, select the desired rule from the list and click the Copy... or
Remove button. You may be prompted to confirm the action. Click OK to confirm.
6). After adding, removing or modifying rules as desired, click the Apply button to save changes.
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
VIGIL Software v8.8 User Manual | VISIX V-Series All-in-One Cameras
67