Removing The Rear Wheel Bearings - APRILIA TUONO 1000 Workshop Manual

CYCLE PARTS
5.7.5.

REMOVING THE REAR WHEEL BEARINGS

•
Remove the rear wheel.
•
Clean the two sides of the hub with a cloth.
Work on the right-hand side of the wheel:
•
Remove the right spacer (1).
•
Remove the seal (2).
•
Remove the circlip (3).
NOTE The circlip (3) is fitted only on the right side of the
wheel.
The edges of the spacer (4) feature slots (A) to allow the
passage of the extractor teeth.
NOTE Use the
- aprilia part# 8140180 (bearing extractor)
• Remove the right bearing with the extractor (5).
• Set aside the inner spacer (4).
Work on the left-hand side of the wheel:
NOTE Use the
- aprilia part# 8140180 (bearing extractor)
•
Remove the left bearing with the extractor (6).
•
Clean the inner part of the hub thoroughly.
NOTE Wash all components with clean detergent.
5 - 90
special tool
special tool
OPT:
OPT:
TUONO 1000