Using The Second Stick Button; Retro-Fitting Switches K And / Or P - Multiplex Royal SX 9 Instructions Manual

3. Assigning a servo for retracts (landing gear)
Main menu: ¤Servo
Assignment
Menu:
Select desired servo (e.g. Servo 9), open by press-
ing ENTER:
9 L. gear UNI
then confirm with ENTER.
Select UNI or MPX as signal format,
confirm with ENTER.
Select 2P, as only the two end-points are of inter-
est for servo travel settings,
confirm with ENTER.
4. Reversing the servo and adjusting the
end-points
Main menu: ¤Servo
Calibrate
Menu:
Sub-menu: 9 L. gear
Parameter: á (to reverse)
P1 and P5 (end-points).
5. Set the transit time if required
Main menu: ¢Control
L. gear
Menu:
Parameter: Time
Time – 4.5s
maximum setting 6.0 seconds.
e. Using the second stick button
If one stick button is already installed, the second
must be connected to the terminal clamps BC.
The button connected at this point must be allocated
as Extra Sw. K> or <P in the software before it can
be assigned as a control or switch.

Tip:
Assign it to <P if the button is in the left-hand stick,
and K> if it is in the right-hand stick.
Main menu: ¡Setup
Assignment
Menu:
Menu point: Switches
Parameter: Extra Sw.
Extra Sw. ->
!
The assignment for Extra Sw. applies to all
the assignment lists. Any switch installed at K or
P and connected to the corner unit is disabled
once you have assigned the Extra Sw.
2P
K>
20.5.3.

Retro-fitting switches K and / or P

Two-position switches can be retro-fitted at positions
K and P at any time:
P
If you wish to install switches in both positions, please
note that the following combinations is possible:
2 x 2-position
NOTE: it is not possible to install three-position
switches.
To accomplish this you must remove the appropriate
corner unit from the transmitter:
a.) Use the T6 TORX screw-
driver (located in clips in the
transmitter back panel) to
undo the four TORX screws
holding the appropriate corner
unit.
b.) Set the switches to centre,
then carefully withdraw the
corner unit from the trans-
mitter. When you remove the
unit, the rotary knob fitted to
the 3-D digi-adjuster on that
side will come loose.
c.) The switch is fitted in the
corner unit and held in place
by the retaining nut supplied.
Keep the wiring the correct
way round: yellow wire facing
the transmitter battery.
d.) Use a small screwdriver to
press the blind cover out of
the front case panel from the
inside.
e.) Re-install the corner unit,
fit the retaining screws, and
push the knob back onto the
shaft of the 3-D digi-adjuster
(note the correct knob posi-
tion: internal shoulder). Insert
the connector directly into the
micro socket located on the
corner unit (illustration shows
switch K).
Manual
K
1 2
3
4
93