13.10.7. Setting A Transition Time - Multiplex Royal SX 9 Instructions Manual

¦Flight phase
¨Exit
1 HOVER X ---
2 CRUISE
3 ACRO
4 AUTOROT
Time

13.10.7. Setting a transition time

The switch from one flight phase to another can occur
immediately, or alternatively you can set a transition
period of 1, 2 or 4 seconds (smooth transition). The
latter reduces the loads on the model and the power
system.
! Exception: flight phase AUTOROT
Applies to helicopters only!!
The transition always occurs immediately when you
switch to the AUTOROT flight phase.
If you switch to any other flight phase (i.e. flight phase
other than AUTOROT), then the transition occurs with
the set delay or immediately, according to your set-
ting.
This is the procedure for setting a transition time
between the flight phases:
- Open the main menu Memory (button I)
- Select the menu Flight phase
- Press ENTER (or press the 3-D digi-adjuster)
to open the menu
- Select the Time line (see Fig. 13.10.7.1.)
- Press ENTER (or press the 3-D digi-adjuster)
to open the set-up window
- Use the 3-D digi-adjuster to set a transition period
(see Fig. 13.10.7.2.):
1sec, 2sec, 4sec or OFF
- Press ENTER (or press the 3-D digi-adjuster)
to confirm the selected setting.
Fig. 13.10.7.1.:
Time line selected
---
---
---
OFF
Fig. 13.10.7.2.:
Time set to 2 sec
Manual
57