Status Display 3 (Timers); Status Display 4 (System Information); The "Royal Sx" Philosophy; Operating The Royal Sx - Multiplex Royal SX 9 Instructions Manual

1
2
3
4
5
Bars
Line 1 Status of the 3-D digi-adjusters ( Status display 1)
Line 2 Current model memory ( Status display 1)
Line 3 Actual battery voltage ( Status display 1)
Line 4 Switch used to select the current flight phase ( 19.4.)
Line 5
Current flight phase with number and name: 1:NORMAL
Bars Current trim positions ( Status display 1)
10.8.3. Status display
The screen only displays those timers to which a
switch has been assigned. After the timer the screen
shows the associated switch (in this example: the Slot
timer is controlled using switch "P"):
1
2
3
4
5
Bars
Line 1 Status of the 3-D digi-adjusters ( Status display 1)
Direction of operation of each timer (here: counting
Line 2
down)
Line 3 Slot timer ( 18.3.)
Line 4 Sum timer ( 18.4.)
Line 5 Interval timer ( 18.5.)
Bars Current trim positions ( Status display 1)
10.8.4. Status display
ROYAL
1
Batt. voltage
2
Battery charge 1998mAh
3
Remaining time
4
Operating time
5
Line 1 Transmitter type: ROYAL SX 9 or 16
Software version: e.g. 3.46,
Loaded language set:
e.g. DE/EN (German / English)
Line 2 Actual battery voltage
Line 3 Available battery charge quantity
Line 4 Calculated remaining transmitter operating time
based on the available battery charge quantity and
the actual current drain. Only displayed if an RF sig-
nal is being transmitted.
The red LED must flash!
Line 5
Transmitter operating time, up to 1000.0 hours,
then restarts at 0.0 h
3
(timers)
4
(system information)
SX16 3.46 DE/EN
M-LINK
8.20V
7.7h
12.4h

The "ROYAL SX" philosophy

11.
11.1.

Operating the ROYAL SX

11.1.1.

Using the keypad

The ROYAL SX is programmed using the keypad and
the two 3-D digi-adjusters. There are eleven buttons in
all.
a. Six buttons for direct access to main menus
L
Setup (Configuration)
H
Control
G
Mixer
K
Servo
A
Timer
I
Memory
b. Special function buttons
Allocate 3-D digi-adjuster for:
altering values in flight
F
calibrating servos
Activate scanner when switching on
Reverse (REVerse) Erase (CLeaR).
Many set-up values (% values) can be restored to
REV/CLR
the default setting using this button
Menu / Open / Close parameter
ENTER

Cursor up / Increase values

Cursor down / Reduce values
c. Text input buttons
The ten buttons with inscribed letters are used for en-
tering text (name of transmitter owner, model, free
mixers, assignment lists):
Text is entered in the manner familiar from mobile
telephones. The two 3-D digi-adjusters can be used to
select individual characters in the input field.
The characters which can be called up by rapidly and
repeatedly pressing one button are printed in small
script below the direct menu access buttons (row 1)
and above the working buttons (row 2).
Manual
 20.1.
 17.1.2.
25