Special Facilities; Using The 3-D Digi-Adjuster To Alter Settings In Flight - Multiplex Royal SX 9 Instructions Manual

At this menu point you can set the fail-safe posi-
tions for the individual servos in the model from the
transmitter:
Open the menu point OFF.
Move the transmitter controls to the positions
which are to be stored as the fail-safe settings.
If you now press the REV/CLR button, the data is
transferred to the receiver. The screen display
ON
changes briefly to
transmission is complete, the marker jumps back
to OFF.
Press the ENTER button to quit this menu point.
The marker now jumps back to
(< 1 sec). When the
set failsafe.
20.

Special facilities

20.1. Using the 3-D digi-adjuster to alter
settings in flight
Many model settings can only be optimised when the
model is in the air. A typical example of this is aileron
differential, or Expo settings.
Each of the two 3-D digi-adjusters can be assigned
any of the parameters which are marked in the menus
with a small hyphen "-".
F
Button is used to unlock / lock the allocated values
for alteration:
Example - aileron differential:
1. Select the parameter Aileron differential
Select the menu £Mixer, Ail.Diff. and press
ENTER to confirm. Select Diff. and confirm again
with ENTER:
2. Press the Accept button
The 3-D digi-adjuster symbol now appears on the
screen instead of the percentage value (%) for the
parameter:
Now press one of the 3-D digi-adjusters to select
the one (left or right) which you wish to use to al-
ter the value in flight.
3. You can now leave the menu and return to the
Status display.
The top line in Status displays 1 - 3 now shows
that aileron differential Ail.Diff. can be ad-
justed using the right-hand 3-D digi-adjuster:
If you now press or rotate the appropriate 3-D digi-
adjuster, the current set-up value for the parameter
appears on the screen for a moment:
Manual
F
89