Menu User; Parameter Pin (Access Code); Parameter Language; Parameter Name - Multiplex Royal SX 9 Instructions Manual

Menu User

14.5.

Parameter PIN (access code)

14.5.1.
The purpose of the PIN (Personal Identification Num-
ber) is to protect the settings and values stored in your
transmitter. When the PIN is active, you can view set-
tings and values, but you cannot change them.
PIN = 0000
The default PIN provides no protection against changes
to the settings and values stored in your transmitter.
PIN = **** (four digits)
The PIN must contain at least one digit which is not "0".
If you enter a PIN, the lock takes effect next time you
switch the transmitter on. You can leaf through all the
menus, but as soon as you try to change anything you
will see this on-screen message:
Entering the correct PIN unlocks the system; the code
lock will be re-activated next time you switch the
transmitter on.
!
If you forget your PIN:
You can reset the PIN to 0000 - and thereby render it
ineffective - using the PC program ROYAL SX-Data-
Manager (free download from the Internet) and the PC
Interface lead # 8 5148 (USB) or # 8 5156 (serial).

Parameter Language

14.5.2.
The ROYAL SX contains two language sets for the
on-screen texts. The default primary language is Eng-
lish, which is selected as the active language.
The default second language is Deutsch (German).
In the menu L, User (or Benutzer) you can toggle
between these two languages using the Language (or
Sprache) parameter.
It is also possible to install other languages in your
transmitter using the DataManager program for the
ROYAL SX. This is available on the Internet from our
website http://www.multiplex-rc.de under DOWNLOADS,
SOFTWARE.
The following language combinations are available:
Code Main language
DE/EN
FR/EN
English
ES/EN
IT/EN
You can find out which language pair is installed in
your transmitter by consulting Status display 4:
ROYAL SX16
M-LINK
Batt. voltage
Battery charge 1998mAh
Remaining time
Operating time
Fig. 14.5.2.1.: Status display 4 showing screen languages

Parameter Name

14.5.3.
The default name on your transmitter is MULTIPLEX.
At this point you can enter your own name with up to
sixteen characters. The name then appears in Status
SX 16
Max Muster
display 1 (Example: Max Muster):
Fig. 14.5.3.1.: Status display 1 showing owner's name
Manual
Second
guage
German
French
Spanish
Italian
3.46 DE/EN
8.20V
7.7h
12.4h
lan-
65