Tracert - TP-Link T2600G-28TS User Manual

Ping Times:
Data Size:
Interval:

16.5.2 Tracert

Tracert test function is used to test the connectivity of the gateways during its journey from the
source to destination of the test data. When malfunctions occur to the network, you can locate
trouble spot of the network with this tracert test.
Choose the menu Maintenance→Network Diagnostics→Tracert to load the following page.
The following entries are displayed on this screen:
Tracert Config

Destination IP:
Max Hop:
and IPv6 are supported.
Enter the amount of times to send test data during Ping testing. The
default value is recommended.
Enter the size of the sending data during Ping testing. The default
value is recommended.
Specify the interval to send ICMP request packets. The default value
is recommended.
Figure 16-7 Tracert
Enter the IP address of the destination device. Both IPv4 and IPv6 are
supported.
Specify the maximum number of the route hops the test data can pass
through.
338
Return to CONTENTS