Port Mirror - TP-Link T2600G-28TS User Manual

Description:
Status:
Speed:
Duplex:
Flow Control:
Jumbo:
LAG:
Note:
1. The switch cannot be managed through the disabled port. Please enable the port which is
used to manage the switch.
2. The SFP ports support 1000M SFP module connection only.

5.1.2 Port Mirror

Port Mirror, the packets obtaining technology, functions to forward copies of packets from
one/multiple ports (mirrored port) to a specific port (mirroring port). Usually, the mirroring port is
connected to a data diagnose device, which is used to analyze the mirrored packets for monitoring
and troubleshooting the network.
Choose the menu Switching→Port→Port Mirror to load the following page.
The following entries are displayed on this screen.
Mirror Session List

Session:
Destination:
Give a description to the port for identification.
Allows you to Enable/Disable the port. When Enable is selected,
the port/LAG can forward the packets normally.
Select the Speed mode for the port. The device connected to the
switch should be in the same Speed and Duplex mode with the
switch. When 'Auto' is selected, the Speed mode will be
determined by auto negotiation.
Select the Duplex mode for the port. When 'Auto' is selected,
the Duplex mode will be determined by auto negotiation.
Allows you to Enable/Disable the Flow Control feature. When
Flow Control is enabled, the switch can synchronize the speed
with its peer to avoid the packet loss caused by congestion.
Allows you to Enable/Disable the Jumbo feature. The default
maximum transmission unit (MTU) size is 1518 bytes. When
Jumbo is enabled, the MTU size is 9216 bytes.
Displays the LAG number which the port belongs to.
Figure 5-2 Mirror Group List
Displays the mirror session number.
Displays the mirroring port.
39