TP-Link T2600G-28TS User Manual page 146

Network Diagram

Configuration Procedure

Step Operation
1 Enable DLDP globally.
2 Enable DLDP on the
specified ports.
3 Configure Shut Mode.
4 Check the ports' state.
The DLDP information of Gigabit Ethernet ports 1/0/27 and 1/0/28 is shown below:
Figure 8-13 DLDP Application Example
Description
Required. On the Ethernet OAM→DLDP→DLDP page,
configure DLDP State as enable under the Global Config
tab in device A and B.
Required. On the Ethernet OAM→DLDP→DLDP page,
configure DLDP State as enable on Gigabit Ethernet ports
1/0/27 and 1/0/28 in the Port Config table in device A and
device B.
Required. On the Ethernet OAM→DLDP→DLDP page,
configure the Shut Mode as auto under the Global Config
tab in device A and B.
Required. On the Ethernet OAM→DLDP→DLDP page,
select ports 1/0/27 and 1/0/28 in the Port Config table and
click the Reset button to bring them up.
134