Status:
Tips:
After adding a global IPv6 address to your switch manually here, you can configure your PC's
global IPv6 address in the same subnet with the switch and login to the switch via its global IPv6
address.
Click Detail to display the following figure:
Detail Information
Interface ID:
IP Address Mode:
IP Address:
Secondary IP:
Interface Status:
Line Protocol
Status:
Displays the status of the global address.
Normal: Indicates that the global address is normal.
Try: Indicates that the global address may be newly
configured.
Repeat: Indicates that the corresponding address is duplicate.
It is illegal to access the switch using this address.
Figure 10-6 The Interface's Detail Information
Displays the ID of the interface, including VLAN interface,
loopback interface, routed port and port channel.
Displays the IP address allocation mode.
None: without ip.
Static: setup manually.
DHCP: allocated through DHCP.
BOOTP: allocated through BOOTP.
Displays the IP address and subnet mask of the interface.
Displays Secondary IP Address and subnet mask.
Displays the interface current working status, which is up when
Admin Status is enable, line protocol is up and IP address is set.
Displays the line protocol status, which is up if any up-link port is
connected to the interface.
187