Pppoe - TP-Link T2600G-28TS User Manual

Configuration Procedure:
Step Operation
1 Install the
software.
2 Configure the 802.1X globally.
3 Configure the 802.1X for the
port.
4 Connect an
server to the switch and do
some configuration.
5 Enable the
globally.
6 Configure the parameters of
the authentication server.
Note:
1. The 802.1X function takes effect only when it is enabled globally on the switch and for the port.
2. The 802.1X function cannot be enabled for LAG member ports. That is, the port with 802.1X
function enabled cannot be added to the LAG.
3. The 802.1X function should not be enabled for the port connected to the authentication server.

13.10 PPPoE

PPPoE ID-Insertion Overview

The PPPoE ID-Insertion feature provides a way to extract a Vendor-specific tag as an

identifier for the authentication, authorization, and accounting (AAA) access requests on an
Ethernet interface. When enabled, the switch attaches a tag to the PPPoE discovery packets,
which is called the PPPoE Vendor-Specific tag and it contains a unique line identifier. There
are two formats of Vendor-specific tags: Circuit-ID format and Remote-ID format. The BRAS
receives the tagged packet, decodes the tag, and uses the Circuit-ID/Remote-ID field of that
tag as a NAS-Port-ID attribute in the RADIUS server for PPP authentication and AAA
(authentication, authorization, and accounting) access requests. The switch will remove the
Circuit-ID/Remote-ID tag from the received PPPoE Active Discovery Offer and
Session-confirmation packets from the BRAS.
In this Chapter the switch will work as a DSLAM.
Description
Required. For the client computers, you are required to
802.1X client
install the TP-LINK 802.1X Client provided on the CD.
Please refer to the software guide in the same directory
with the software for more information.
Required. By default, the global 802.1X function is
disabled. On the Network Security→802.1X→Global
Config page, configure the 802.1X function globally.
Required. On the Network Security→802.1X→Port
Config page, configure the 802.1X feature for the port of
the switch basing on the actual network.
authentication Required. Record the information of the client in the LAN
to
corresponding authentication username and password for
the client.
AAA function Required. On the Network Security→AAA→Global
Conifg page, enable the AAA function globally.
Required. On the Network Security→AAA→RADIUS
Server Conifg page, configure the parameters of the
RADIUS server.
the authentication
282
server and configure the