16.2.2 SFlow Sampler
Configuration Procedure:
Configure one or more ports to be a sampler and configure relevant parameters under the
Sampler Config. One port can only be bound to one collector.
Entry Description:
Select
Port:
Collector ID:
Ingress Rate:
Egress Rate:
Max Header:
LAG:
Figure 16-4 sFlow Sampler
Configure the desired port to be the sFlow sampler.
Displays the port of the switch here.
Select the sFlow collector for the sFlow sampler. The sampler will
send sFlow datagrams to corresponding collector via the sFlow
agent. When the Collector ID is 0, it means no collector is
selected.
Specify the ingress sampling frequency of the sFlow sampler.
When a sample is taken, the value indicates how many packets to
skip before the next sample is taken.
Specify the egress sampling frequency of the sFlow sampler.
When a sample is taken, the value indicates how many packets to
skip before the next sample is taken.
Specify the maximum number of bytes that should be copied from
a sampled packet.
Displays the LAG number which the port belongs to.
331