Vlan Config - TP-Link T2600G-28TS User Manual

Note:
1. Fast Leave on the port is effective only when the host supports IGMPv2 or IGMPv3.
2. When both Fast Leave feature and Unknown Multicast Discard feature are enabled, the
leaving of a user connected to a port owning multi-user will result in the other users
intermitting the multicast business.

9.1.3 VLAN Config

Multicast groups established by IGMP Snooping are based on VLANs. On this page you can
configure different IGMP parameters for different VLANs.
Choose the menu Multicast→IGMP Snooping→VLAN Config to load the following page.
The following entries are displayed on this screen:
VLAN Config

VLAN ID:
Router Port Time:
Member Port Time:
Figure 9-7 VLAN Config
Enter the VLAN ID to enable IGMP Snooping for the desired
VLAN.
Specify the aging time of the router port. Within this time, if the
switch doesn't receive IGMP query message from the router port,
it will consider this port is not a router port any more. By default, it
is 0 and the global router-time will be used.
Specify the aging time of the member port. Within this time, if the
switch doesn't receive IGMP report message from the member
port, it will consider this port is not a member port any more. By
default, it is 0 and the global member-time will be used.
145