L2Pt Config - TP-Link T2600G-28TS User Manual

5.5.1 L2PT Config

Choose the menu Switching→L2PT→L2PT Config to load the following page.
Configuration Procedure:
1) Enable the Layer 2 Protocol Tunneling globally under Global Config.
2) Configure the tunneling and protocol type on the speicified port under Port Config.
3) Click Apply to save your configurations.
Entry Explannation:
UNIT:1/LAGS:
Select:
Type:
Protocol:
Figure 5-2 L2PT Config
Click 1 to configure the physical ports. Click LAGS to configure the
link aggregation groups.
Specify the port(s) to configure its L2PT feature. It is multi-optional.
Choose the port type according to its connecting device in the
network.
• None: Disable the L2PT on this port.
• UNI: Specify the port's type as UNI if it is connecting to the user's
local network.
• NNI: Specify the port's type as NNI if it is connecting to the ISP
network.
Select the supported Layer 2 protocol type. Packets of the specified
protocol will be encapsulated with their destination MAC address
before they are sent to the ISP network. Packets will be
decapsulated to restore their Layer 2 protocol and MAC address
information before they are sent to the customer network.
• STP: Enable protocol tunneling for the STP packets.
• GVRP: Enable protocol tunneling for the GVRP packets.
• 01000CCCCCCC: Enable protocol tunneling for the packets with
63