Port Config - TP-Link T2600G-28TS User Manual

Choose the menu LLDP→Basic Config→Global Config to load the following page.
The following entries are displayed on this screen:
Global Config

LLDP:
Parameters Config

Transmit Interval:
Hold Multiplier:
Transmit Delay:
Reinit Delay:
Notification Interval:
Fast Start Count:

15.1.2 Port Config

On this page you can configure all ports' LLDP parameters.
Figure 15-1 Global Configuration
Choose to enable/disable LLDP.
This parameter indicates the interval at which LLDP frames are
transmitted on behalf of this LLDP agent.
This parameter is a multiplier on the Transmit Interval that
determines the actual TTL (Time To Live) value used in an
LLDPDU. TTL = Hold Multiplier * Transmit Interval.
This parameter indicates the delay between successive LLDP
frame transmissions.
This parameter indicates the amount of delay from LLDP becomes
"disable" until re-initialization will be attempted.
Configure the interval of Trap message which will be sent from
local device to network management system.
When the port's LLDP state transforms from Disable (or Rx_Only)
to Tx&Rx (or Tx_Only), the fast start mechanism will be enabled,
that is the transmit interval will be shorten to a second, and
multiple LLDP frames will be sent out with the duration based on
this parameter.
315