Arctic Cat ROV 2013 Service Manual page 93

Battery (bAtt) Diagnostic Mode
Display: System DC voltage.
DTC: P0562, P0563, P2531, P2532
Usage: Verify system voltage under following condi-
tions.
1. Battery voltage with engine and accessories off
(>12.2 VDC for fully charged).
2. Battery voltage with engine running (charging = 13.8
VDC or greater).
90
3. Battery voltage with electrical accessories operating,
engine idling (13.5 VDC or greater).
4. Battery voltage starter cranking (10.5-11.5 VDC).
DIAGNOSTIC TROUBLE CODES
(DTC)
If an EFI or related chassis component fails or an out-of-
tolerance signal is detected by the ECM, a diagnostic
trouble code (DTC) will be generated in the ECM and
displayed on the LCD. The DTC will be displayed
alternately with a wrench icon or malfunction indicator
light (MIL). The DTC will continue to flash, until the
malfunction is corrected and the code cleared.
EFI004
Code List
NOTE: Each of the following numerical codes will
have a one-letter prefix of C, P, or U. A "C" prefix
denotes a chassis malfunction, a "P" prefix
denotes a power train malfunction, and a "U" pre-
fix denotes a loss of communication with the
gauge.
 NOTE: Normal malfunction codes are cleared from
the LCD when the component is replaced or the mal-
function is corrected; however, intermittent codes
must be cleared as noted in the code chart.