Arctic Cat ROV 2013 Service Manual page 74

5. Remove the two shoulder bolts and nuts securing the
radiator to the frame; then disconnect the upper and
lower coolant hoses.
6. Lift the radiator assembly from the vehicle. Account
for two upper and two lower rubber mounting grom-
mets.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Flush the radiator with water to remove any contami-
nants.
2. Inspect the radiator for leaks and damage.
3. Inspect all hoses for cracks and deterioration.
4. Inspect all fasteners and grommets for damage or
wear.
INSTALLING
1. Place the radiator into position making sure the
grommets are correctly installed; then secure to the
mounts with the two shoulder bolts and nuts. Tighten
securely.
PR183A
2. Connect the upper and lower coolant hoses to the
radiator and secure with the appropriate hose clamps;
then connect the cooling fan wire connector to the
main harness.
PR184A
3. Open the high-point bleed screw on the thermostat
housing to allow trapped air to escape. Tighten
securely after filling.
4. Pour the recommended coolant into the radiator and
secure the radiator cap.
5. Place the storage box into position and using a
smooth, flat pry-bar, pry the center of the box past
the dash mount; then secure with the appropriate fas-
teners.
6. Install the two sheet metal screws in the dash.
Tighten securely.
7. Start the engine and warm up to operating tempera-
ture; then verify the coolant level is at the bottom of
the stand pipe in the radiator neck. Add coolant as
necessary.
PR184A
PR183A
PR187
71