Starter Motor; Starter Relay - Arctic Cat ROV 2013 Service Manual

RESISTANCE
(Crankshaft Position Sensor)
1. Set the meter selector to the OHMS position.
2. Connect the red tester lead to the blue wire; then con-
nect the black tester lead to the green wire. The
meter reading must be within specification.
AC VOLTAGE
NOTE: The battery must be at full charge for
these tests.
Crankshaft Position Sensor
1. Set the meter selector to the AC Voltage position.
2. Connect the red tester lead to the blue wire; then con-
nect the black tester lead to the green wire.
3. Crank the engine over using the electric starter.
4. The meter reading must be within specification.

Starter Motor

 NOTE: Preliminary checks may be performed on
this component using the diagnostic mode on the
LCD gauge (see EFI Diagnostic System in this sec-
tion).
NOTE: The starter motor is not a serviceable
component. If the starter is defective, it must be
replaced.
REMOVING
1. Disconnect the battery.
CAUTION
Always disconnect the negative battery cable from the
battery first; then disconnect the positive cable.
2. Remove the nut securing the positive cable to the
starter; then remove the cable from the starter.
3. Remove the two cap screws securing the starter with
ground wires to the crankcase; then remove the
starter. Account for the wiring forms and an O-ring.
INSTALLING
1. Apply a small amount of grease to the O-ring seal on
the starter; then install the starter into the crankcase.
Secure with two machine screws and wiring forms.
2. Secure the positive cable to the starter with the nut.
3. Connect the battery.
TESTING VOLTAGE
Perform this test on the starter positive terminal. To
access the terminal, slide the boot away.
NOTE: The ignition switch must be in the ON posi-
tion, and the shift lever in the NEUTRAL position.
1. Set the meter selector to the DC Voltage position.
2. Connect the red tester lead to the starter terminal;
then connect the black tester lead to ground.
3. With the starter button depressed, the meter must
show battery voltage and the starter should operate.
NOTE: If the meter showed battery voltage but
the starter did not operate or operated slowly,
inspect battery voltage (at the battery), starter con-
dition, and/or ground connections.
NOTE: If the meter showed no battery voltage,
inspect the main fuse, ground connections, starter
lead, battery voltage (at the battery), starter relay,
or the neutral start relay.

Starter Relay

1. Remove the seat base and battery cover; then using
the multimeter set to the DC Voltage position, check
the relay as follows.
2. Connect the red tester lead to the positive battery ter-
minal; then connect the black tester lead to the starter
cable connection on the starter relay. The meter must
show battery voltage.
AR607D
PR296
85