Arctic Cat ROV 2013 Service Manual page 68

14. Connect the gasline hose to the throttle body making
sure the gasline hose connector fully engages and
locks onto the fuel rail.
15. Connect the MAP sensor connector (A), fuel injector
connector (B), ISC connector (C), and TPS connector
(D); then install new nylon ties as noted during removing.
HDX031A
16. Pour the recommended amount of oil and coolant
into the engine and radiator; then loosen the cool-
ant bleed screw to allow trapped air to escape.
When clear coolant flows, tighten the bleed screw.
HDX138B
17. Connect the negative battery cable to the battery
and install the battery cover.
18. Install the center skid plate, center floorboard, and
seat base; then install the seat back and seat.
19. Start the engine and check for leaks allowing to
warm up for several minutes; then shut the engine
off and check engine oil and coolant levels.
HDX136A
HDX158B
65