Tilt Sensor - Arctic Cat ROV 2013 Service Manual

Tilt Sensor

! WARNING
Incorrect installation of the tilt sensor could cause sud-
den loss of engine power which could result in loss of
vehicle control resulting in injury or death.
CAUTION
Do not drop the tilt sensor as shock can damage the
internal mechanism.
SUPPLY VOLTAGE
1. Disconnect the three-wire connector from the sensor;
then select DC Voltage on the multimeter and con-
nect the red tester lead to the orange wire (C) and the
black tester lead to the black wire (A).
2. Turn the ignition switch to the ON position. The
multimeter should read battery voltage. If battery
voltage is not indicated, check the 30-amp fuse, wir-
ing harness, or the ignition switch.
3. Remove the red tester lead and connect to the blue/
brown wire (B). The multimeter should read approx-
imately 2.5 DC volts. If the specified voltage is not
indicated, check wire connections at the ECM or
substitute another ECM to verify the test.
 REMARQUE: Do not attempt to substitute an ECM
from a different model as the system will not allow it
to start.
92
OUTPUT VOLTAGE
NOTE: Needle adapters will be required on the
multimeter leads as the following tests are made
with the sensor connected.
1. Connect the three-wire plug to the sensor; then
remove the right-side mounting screw securing the
sensor to the rear frame.
2. Install the needle adapters to the multimeter leads;
then select DC Voltage on the multimeter.
3. Connect the red tester lead to the blue/brown wire
(B) and the black tester lead to the black/yellow wire
(A); then turn the ignition switch ON and observe the
meter. The meter should read 0.8-3.0 DC volts.
CD706A
4. Tilt the sensor 60° or more to the left and right
observing the meter. The meter should read 4.0-8.0
DC volts after approximately one second in the tilted
position. If the meter readings are not as specified,
the tilt sensor is defective.
CD706B
CD707
CD705B
CD709