Arctic Cat ROV 2013 Service Manual page 132

15. Lubricate the seal on the air chamber with Fox Float
Fluid.
16. Slide the air chamber onto the shock body.
17. Add 1 cc of Fox Float Fluid into the chamber.
18. Thread the air chamber into the end cap until hand-
tight.
FS167
 NOTE: Prior to installing the air chamber, make sure
the end cap O-ring is properly positioned in the
chamber.
19. Invert the shock and secure by the end cap to assure
the air chamber is tight.
FS168
20. Using a hand pump, inflate the air chamber to the
appropriate pressure.
Payload
0-250 lb
250-500 lb
500-750 lb
750-1000 lb
FS169
FS170
Do not exceed 150 psi in the shock.
Pressure
15 psi
60 psi (min)
90 psi (min)
150 psi
! WARNING
FS171
FS172
FS173
129