Drive Axles - Arctic Cat ROV 2013 Service Manual

8. Secure the lower shock eyelets with cap screws and
lock nuts. Tighten to 20 ft-lb.
9. Install the brake calipers. Secure with new "patch-
lock" cap screws tightened to 20 ft-lb.
10. Connect the front drive actuator connector to the
main harness; then secure the wires to the frame with
nylon ties.
11. Apply a light coat of multi-purpose grease to the hub
splines; then install the hubs and nuts. Tighten to 200
ft-lb; then install new cotter pins.
108
PR193
12. Install the wheels and tighten in 20 ft-lb increments
to 80 ft-lb.
13. Remove the vehicle from the support stand.
14. Install the belly panel.
REMOVING REAR DRIVE AXLE
1. Secure the vehicle on a support stand to elevate the
wheels.
AF897D
Make sure the vehicle is solidly supported on the sup-
port stand to avoid injury.
2. Place the transmission in park; then remove the
wheels.
3. Remove the cotter pins securing the axle nuts; then
remove the nuts.
PR264A
4. Slide the hub out of the knuckle and set aside.

Drive Axles

! WARNING
PR256
KX041