Arctic Cat ROV 2013 Service Manual page 146

2. Install the knuckle to the upper and lower ball joints
and secure with the two cap screws. Tighten to 35 ft-
lb.
3. Install the tie rod end and secure with the nut (coated
with red Loctite #271). Tighten to 30 ft-lb; then
install a new cotter pin and spread the pin.
NOTE: During assembling, new cotter pins
should be installed.
4. Apply a small amount of grease to the hub splines.
PR292A
5. Install the hub assembly onto the splines of the shaft.
PR289
6. Secure the hub assembly with the nut. Tighten to 200
ft-lb.
PR202
7. Install a new cotter pin and secure by spreading as
shown.
PR203
PR290A
CD009
PR256
143