Arctic Cat ROV 2013 Service Manual page 41

NOTE: The adjuster shaft will be drawn into the
tensioner as the adjuster screw is rotated clock-
wise. The adjuster shaft tension will be released in
step 24.
23. Place the chain tensioner adjuster assembly and gas-
ket into position on the cylinder and secure with the
two cap screws.
24. Using a flat-blade screwdriver, rotate the adjuster
screw inside the tensioner counterclockwise until all
tension is released; then install the cap screw into the
end of the chain tensioner.
38
CD501
25. Loosen the four adjuster screw jam nuts; then loosen
the four adjuster screws on the rocker arms in the
valve cover.
26. Apply a thin coat of Three Bond Sealant to the mat-
ing surfaces of the cylinder head and valve cover.
CD469
27. Place the valve cover into position.
NOTE: At this point, the rocker arms and adjuster
screws must not have pressure on them.
28. Install the four top side cap screws with rubber wash-
ers; then install the remaining cap screws. Tighten
only until snug.
CD470
CD471
CC005D
CC275D