Arctic Cat ROV 2013 Service Manual page 67

8. Install the starter cable to the starter motor, secure
with the nut, and tighten securely; then secure the
engine/harness ground wires to the engine with a cap
screw and tighten to 8 ft-lb.
9. Connect the shift cable to the shift arm and install the
E-clip; then secure the shift cable bracket to the
engine case and tighten the engine case screws to 8
ft-lb. Connect the gear position switch connector.
10. On the left side, connect the ECT sensor connec-
tor, speed sensor connector, and spark plug cap.
64
HDX135A
11. Install the throttle body into the intake manifold boot
and secure with the clamp. Tighten to 30 in.-lb.
12. Install the air filter assembly and secure to the frame
with four sheet metal screws; then secure the intake
HDX149A
boot with the clamp and tighten securely.
13. Connect the IAT sensor connector to the IAT sen-
sor and the crankcase breather tube to the crank-
case; then install the air filter intake tube and
PR825A
secure with a clamp and sheet metal screw.
HDX135A
HDX137A
HDX148A