Front A-Arms - Arctic Cat ROV 2013 Service Manual

21. Install the valve cap.
22. Install the spring using an appropriate spring com-
pressor and secure with the retaining ring.
INSTALLING
1. Install the shock absorber (valve stem at the top) and
secure with the cap screws. Tighten new lock nuts to
35 ft-lb.
2. Lower the vehicle to the ground.

Front A-Arms

REMOVING
1. Secure the vehicle on a support stand to elevate the
front wheels; then remove the wheels.
! WARNING
Make sure the vehicle is solidly supported on the sup-
port stand to avoid injury.
2. Remove the cotter pin from the nut. Discard the cotter
pin.
3. Remove the nut securing the hub.
4. Remove the brake caliper. Account for two cap
screws.
130
5. Remove the hub assembly.
FS174
6. Remove the cotter pin and slotted nut securing the tie
rod end to the knuckle; then remove the tie rod end
from the knuckle.
7. Remove the cap screws securing the ball joints to the
knuckle.
Support the knuckle when removing the cap screws or
damage to the threads will occur.
8. Tap the ball joints out of the knuckle; then remove the
knuckle.
9. Remove the lower shock absorber eyelet from the
upper A-arm.
PR257
10. Remove the cap screws securing the A-arms to the
frame.
CAUTION
CD007
PR193
AF626D