Rear A-Arms - Arctic Cat ROV 2013 Service Manual

7. Install the tie rod end and secure with the nut (coated
with red Loctite #271). Tighten to 30 ft-lb; then install
a new cotter pin and spread the pin to secure the nut.
NOTE: During assembly, new cotter pins should
be installed.
8. Apply grease to the hub and drive axle splines; then
install the hub assembly onto the drive axle.
9. Secure the hub assembly with the nut. Tighten only
until snug.
10. Secure the brake caliper holder to the knuckle with
two new "patch-lock" cap screws. Tighten to 20 ft-lb.
132
AF628D
11. Secure the hub nut (from step 9) to the shaft/axle.
Tighten to 200 ft-lb.
12. Install a new cotter pin and spread the pin to secure the
nut.
NOTE: If the cotter pin cannot be inserted due to
misalignment of the hole in the axle and the slots
in the nut, tighten the nut until properly aligned.
AF618D
13. Install the wheel and tighten in 20 ft-lb increments to
80 ft-lb.
14. Remove the vehicle from the support stand.
REMOVING
1. Secure the vehicle on a support stand to elevate the
.
wheels
PR290A
Make sure the vehicle is solidly supported on the sup-
port stand to avoid injury.
2. Place the transmission in park.
3. Remove the wheel.
4. Remove the cotter pin securing the hex nut; then
remove the hex nut.

Rear A-Arms

! WARNING
PR377B
PR260