Arctic Cat ROV 2013 Service Manual page 119

NOTE: During assembly, new cotter pins should
be installed.
3. Remove the hub nut securing the hub.
4. Remove the brake caliper (front only).
5. Remove the hub assembly.
6. Remove the four cap screws securing the brake disc.
CLEANING AND INSPECTING
 NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Clean all hub components.
2. Inspect all threads for stripping or damage.
3. Inspect the brake disc (if applicable) for cracks or
warping.
116
4. Inspect the hub for pits, cracks, loose studs, or spline
wear.
REPLACING WHEEL STUDS
1. Secure the hub in a suitable holding fixture and
remove the brake disc (if applicable).
2. Drive the damaged stud out of the hub; then place the
new stud into the hub and thread on an appropriate
flange nut.
PR257
3. Using a socket and ratchet handle, tighten the nut
until the stud is fully drawn into the hub.
PR243A
INSTALLING
1. Secure the brake disc (if applicable) to the hub with
the four cap screws coated with red Loctite #271.
Tighten to 15 ft-lb.
2. Apply grease to the splines in the hub.
PR254A
PR250
PR252A
PR254B