Floor; Dashboard - Arctic Cat ROV 2013 Service Manual

Floor

REMOVING
1. Remove the seat, seat back, and seat base.
2. Remove the self-tapping screws securing the side
foot restraints.
3. Remove the center floorboard.
4. While pulling forward on the upper-rear of the floor,
lift the rear part of the floor above the seat locating
stud.
NOTE: To aid in removing, insert a small wood
block to hold in position.
5. From the opposite side of the vehicle, repeat step 3;
then lift the rear of the floor up and lift the floor out
of the vehicle.
CLEANING AND INSPECTING
 NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Clean the floor with soap and water.
2. Inspect the floor for cracks or holes.
INSTALLING
1. Place the front of the floor into position in the vehi-
cle first; then lower the rear and push past the seat
locating studs.
2. Secure the floor with the cap screws and self-tap-
pings screws.
3. Install the center floorboard; then install the seat
base, seat back, and seat.
HDX132A
REMOVING
1. Remove the steering wheel and steering shaft
boot.
2. Remove two machine screws securing the steering
shaft boot support to the steering support and
remove the boot support.
PR163
3. Remove the six sheet metal and three machine
screws securing the dash assembly to the frame;
then remove the shift lever grip and locking nut.
4. Disconnect the gauge plug, dash harness, and
park/seat belt indicator light connector and remove
the dash assembly.
5. Slide the dash assembly rearward and off the steer-
ing shaft and shift lever assemblies.
PR164

Dashboard

PR762A
149