Hood; Fenders - Arctic Cat ROV 2013 Service Manual

Hood

REMOVING
1. Open the hood; then disconnect the four headlight
connectors and remove two nylon ties.
2. Loosen but do not remove the four cap screws and
flange nuts securing the hood hinge to the frame;
then lower the hood.
3. Finish removing the cap screws and flange nuts
(from step 2); then remove the hood assembly.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all hood components with soap and water.
2. Inspect the hood for cracks and/or loose fasteners.
3. Inspect for any missing decals.
INSTALLING
1. Place the hood into position on the vehicle; then
install the two outside cap screws and flange nuts.
Finger-tighten only at this time.
2. Open the hood; then install the remaining two cap
screws and flange nuts. Tighten all four securely.
148
3. Connect the four headlight connectors; then secure
the wires with two new nylon ties.
PR328A
REMOVING
Remove three torx-head screws securing each fender to
the frame. Account for a stiffener bracket on the front

fenders.

PR332A
INSTALLING
Place the appropriate fender into position and secure with
existing hardware.
Fenders
PR332
PR332B
PR311A