Arctic Cat ROV 2013 Service Manual page 47

NOTE: The sharp side of the snap ring should be
facing outward.
2. Install the water pump drive gear drive pin and the
drive gear (with the flat side of the gear facing out-
ward as noted in removing); then secure with the
snap ring.
NOTE: The sharp side of the snap ring should be
facing outward.
NOTE: Once the gears are secured, remove the
oil passage plug from the crankcase.
3. Install the two starter gear shafts; then install the two
starter gears (with the beveled side of the intermedi-
ate gear facing inward as noted in removing).
44
CD949
4. In order on the crankshaft, install a washer, ring gear,
key, and the magneto rotor. Secure with the nut (threads
coated with red Loctite #271). Tighten to 105 ft-lb.
CD946A
CD944
5. Install the shift cam plate and washer onto the shift
cam shaft; then coat the cap screw threads with red
Loctite #271 and tighten securely.
CD139
PR447A
CD948A
CD940B