Arctic Cat ROV 2013 Service Manual page 57

NOTE: To aid in installing, it is recommended the
assemblies are kept together and IN ORDER.
1. Remove the secondary driven shaft assembly (A)
noting the location of the bearing locating pins.
Account for the bearing C-ring.
2. Remove the reverse idler gear assembly (F). Account
for all washers, shaft, bushing, and the gear.
3. Remove the shift shaft (H); then remove the two
forks taking note of the direction of the tabs on the
forks for assembling purposes.
4. Remove the gear shift shaft (G) noting the location
of the two holes on the end of the shaft. Account for
a washer and a spacer.
5. Remove the countershaft assembly (D). Account for
a washer on each end of the countershaft.
54
NOTE: Do not disassemble the countershaft
assembly unless necessary. If necessary, see Ser-
vicing Center Crankcase Components sub-sec-
tion.
6. Using a rubber mallet, tap on the crankcase to
CD267
remove the driveshaft (E).
7. Note the timing marks on the crank balancer gear (B)
CC668
and crankshaft gear (C) for assembling purposes;
then slide the crank balancer gear off the crank bal-
ancer. Account for the key in the keyway.
8. Remove the crank balancer.
NOTE: There is a flat spot on the crank balancer
DE677A
bearing flange to allow clearance past the crank-
shaft.
CC674
CC675
CD826