Checking/Adjusting Front Wheel Alignment; Front Bumper Assembly - Arctic Cat ROV 2013 Service Manual

Checking/Adjusting Front
Wheel Alignment
NOTE: All measurements and adjustments must
be made with the vehicle unloaded.
Mark the center-line of the front tires at the front and rear
of the tire; then using a tape measure, measure and record
the distance between the marks at the front and rear. The
front measurement should be 6-12 mm (1/4-1/2 in.)
greater than the rear measurement (toe-out).
To adjust the wheel alignment, use the following proce-
dure.
1. Center the steering wheel; then using an open-end
wrench to hold the tie rod ends, loosen the right-side
and left-side jam nuts.
Always use a wrench to hold the tie rod ends when loos-
ening or tightening the jam nuts or damage to the boots
could occur.
2. Turn the left-side and right-side tie rods in equal
increments to achieve the proper toe-out; then
tighten the jam nuts securely.

Front Bumper Assembly

PR087A
REMOVING
Remove four cap screws and nuts. Account for four lock
washers and eight flat washers.
CLEANING AND INSPECTING
HDX098B
NOTE: Whenever a part is worn excessively, cracked,
or damaged in any way, replacement is necessary.
1. Clean all bumper components with hot, soapy water.
2. Inspect all welds for cracking or bending.
INSTALLING
Place the bumper assembly into position on the frame;
then secure with the four cap screws and nuts making
sure the flat washers and lock washers are properly posi-
tioned. Tighten securely.
PR085A
CAUTION
PR086
PR327A
147