Lcd Gauge/Indicator Lights - Arctic Cat ROV 2013 Service Manual

7. Shift the transmission through all positions making
sure the gear position icons indicate the appropriate
gears selected and that the Park Indicator illuminates
only when fully in Park. (See Shift Lever - Checking
Shift Cable Adjustment in the Periodic Maintenance
section).
LCD Gauge/Indicator
Lights
REPLACING
1. Remove the steering wheel; then remove the steering
wheel boot.
2. Remove the two machine screws securing the steer-
ing wheel boot support to the steering support assem-
bly. Remove the boot support.
3. Remove the six screws securing the dash panel to the
frame; then remove the shifter handle and shift lever
boot.
4. Slide the dash panel to the rear sufficiently to access
the components.
5. Remove the nuts securing the gauge assembly to the
dash; then unplug the multi-pin connector and
remove the gauge from the vehicle.
146
6. Place the new gauge into the dash panel opening;
then place the gauge holder over the mounting
screws and secure with the nuts.
7. Plug the multi-pin connector into the gauge; then
turn the ignition switch to the ON position and check
gauge functions.
8. Slide the dash into position and secure with the six
screws.
9. Install the shifter handle; then install the shift lever
boot.
10. Install the steering wheel boot support.
PR762A
11. Install the steering boot onto the boot support.
12. Install the steering wheel; then with a drop of red
Loctite #271 on the threads of the steering shaft,
install the nut and tighten to 25 ft-lb.
13. Install the lock clip and steering wheel cover.
PR181A
PR284A
PR762A
HDX131A