Arctic Cat ROV 2013 Service Manual page 54

4. Grease the driven gear pin and insert it into the oil
pump shaft; then install the driven gear (noting the
direction of the sides of the gear from removing).
Secure with a snap ring.
NOTE: When installed correctly, the sides of the
drive and driven gears will be flush with each
other.
5. Install the clutch shoe assembly and secure with the
flange nut (threads coated with red Loctite #271).
Tighten to 221 ft-lb.
CD991
6. Install the clutch cover alignment pins into the crank-
case, apply oil to the cover gasket, and install the
gasket onto the crankcase.
7. Install the one-way clutch onto the clutch shoe
assembly.
CD985A
When installed correctly, the green dot (or the word
OUTSIDE) on the one-way clutch is visible.
8. Lightly grease the clutch housing seal; then insert the
left fixed drive spacer.
CD984
CAUTION
PR410A
PR399A
CF088A
51