Arctic Cat ROV 2013 Service Manual page 48

6. Install the shift cam stopper, spring, and two wash-
ers; then coat the threads on the mounting stud with
red Loctite #271 and install the nut. Tighten securely.
7. Install the shift shaft with two washers making sure
to align the timing mark on the shift shaft with the
mark on the shift cam plate.
CD935A
8. Lubricate the magneto cover gasket with fresh
engine oil; then place it into position on the two
alignment pins. Make sure the outer shift shaft
washer is in place.
CD934
9. Install the magneto cover and secure with the cap
screws. Tighten only until snug.
10. Place the spacer into position on the crankshaft mak-
ing sure a new, lubricated O-ring is inside the spacer.
Tighten the flange nut to 28 ft-lb.
PR434A
11. Tighten the cap screws (from step 9) to 8 ft-lb.
12. Clean the countershaft and trigger splines thoroughly
and install the inner snap ring onto the shaft; then
apply green Loctite #620 to the trigger and counter-
shaft splines and install the trigger. Secure with a flat
washer and outer snap ring.
CD954A
CD927A
PR431A
PR465
45